Acer Aspire M1935 Betriebsanweisung PDF herunterladen (Seite 21)

English

Frequently asked questions

The following questions are possible situations that may arise during the

use of your computer and each is followed by easy answers and solutions

to the situation.

Q: I pressed the power switch but the system did not boot up.

A: Check the LED located above the power switch.

If the LED is not lit, no power is being applied to the system. Do any of the

following:

• Check if the voltage selector switch located on the rear panel of the

computer is set to the correct voltage.

• Check if you plugged the power cable properly into an electrical

outlet.

• If you are using a power strip or AVR, make sure that it is plugged in

and turned on.

If the LED is lit, check the following:

• Is a non-bootable (non-system) diskette in the floppy drive? If yes,

remove or replace it with a system diskette and press Ctrl + Alt + Del

to restart your computer.

• The operating system files may be damaged or missing. Insert the

start-up disk you created during Windows setup into the floppy drive

and press Ctrl + Alt + Del to restart your computer. This will

automatically diagnose your system and make necessary fixes.

However, if the diagnostic utility still reports a problem, then you may

have to perform the recovery process to restore your system to its

original default factory settings.

Note: For more information about recovering your system,

refers to the RCD instruction sheet.

Q: Nothing appears on the screen.

A: Your computer's power management function automatically blanks

the screen to save power. Just press any key to turn the display back on.

If pressing a key does not work, you can restart your computer. If

restarting your computer does not work, contact your dealer or the

technical support center for assistance.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Keine Kommentare

Acer Aspire M1935 Betriebsanweisung Seite 21