Acer Veriton 3900 Betriebsanweisung PDF herunterladen (Seite 81)

Frequently asked questions

The following questions indicate possible situations that may arise during the

use of your computer and each is followed by easy answers and solutions.

I pressed the power switch but the system did not boot up.

Check the LED located above the power switch.

If the LED is not lit, no power is being applied to the system. Try the following:

• Check if the voltage selector switch located on the rear panel of the

computer is set to the correct voltage.

• Check if you properly plugged the power cable into an electrical outlet.

• If you are using a power strip or AVR, make sure it is plugged in and

turned on.

If the LED is lit, check the following:

• Is a nonbootable (nonsystem) diskette in the floppy drive? If yes, remove or

replace it with a system diskette and press <Ctrl> + <Alt> + <Del> to restart

your computer.

• The operating system files may be damaged or missing. Insert the startup

disk you created during Windows setup into the floppy drive and press

<Ctrl> + <Alt> + <Del> to restart your computer. This will automatically

diagnose your system and make necessary fixes. However, if the diagnostic

utility still reports a problem, then you may have to perform the recovery

process to restore your system to its original default factory settings.

Note: For more information about recovering your system,

see "Acer eRecovery Management" on page 11.

Nothing appears on the screen.

Your computer's power management function automatically blanks the screen

to save power. Just press any key to turn the display back on.

If pressing a key does not work, you can restart your computer. If restarting

your computer does not work, contact your dealer or technical support center

for assistance.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 101 102

Keine Kommentare

Acer Veriton 3900 Betriebsanweisung Seite 81