Acer Altos R700 Series Bedienungsanleitung Seite 61

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 135
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 60
51
Power-On Self-Test (POST)
Each time you turn on the system the BIOS begins execution of the
Power-On Self-Test (POST). POST discovers, configures, and tests the
processors, memory, keyboard, and most installed peripheral devices.
The time needed to test memory depends on the amount of memory
installed. POST is stored in flash memory.
1 Turn on your video monitor and system. After a few seconds, POST
begins to run and displays a splash screen.
2 While the splash screen is displayed:
Press <F2> to enter the BIOS Setup (see “BIOS Setup”)
OR
Press <Esc> to view POST diagnostic messages and change the
boot device priority for this boot only (see “Temporarily
Changing the Boot Device Priority” on page 52).
3 After pressing <F2> or <Esc> during POST, you can press <Ctrl+A>
to run the SCSISelect Utility. For more information, see“Running
the Adaptec SCSISelect Utility” on page 54.
4 If you do not press <F2> or <Esc> and do NOT have a device with
an operating system loaded, the boot process continues and the
system beeps once. The following message is displayed:
Operating System not found
5 At this time, pressing any key causes the system to attempt a
reboot. The system searches all removable devices in the order
defined by the boot priority.
BS811.f/cppl!!Qbhf!62!!Uvftebz-!Opwfncfs!37-!3113!!21;19!BN
Seitenansicht 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 134 135

Kommentare zu diesen Handbüchern

Keine Kommentare