Acer Altos R700 Series Bedienungsanleitung PDF herunterladen (Seite 93)

Initial System Startup

Problems that occur at initial system startup are usually caused by

incorrect installation or configuration. Hardware failure is a less

frequent cause.

Checklist

• Are all cables correctly connected and secured?

• Are the processors fully seated in their sockets on the server

board?

• Are all add-in PCI boards fully seated in their slots on the server

board?

• Are all jumper settings on the server board correct?

• Are all jumper and switch settings on add-in boards and peripheral

devices correct? To check these settings, refer to the

manufacturer’s documentation that comes with them. If

applicable, ensure that there are no conflicts-for example, two

add-in boards sharing the same interrupt.

• Are all DIMMs installed correctly?

• Are all peripheral devices installed correctly?

• If the system has a hard disk drive, is it properly formatted or

configured?

• Are all device drivers properly installed?

• Are the configuration settings made in BIOS Setup correct?

• Is the operating system properly loaded? Refer to the operating

system documentation.

• Did you press the system power on/off switch on the front panel to

turn the server on (power on light should be lit)?

• Is the system power cord properly connected to the system and

plugged into a NEMA 5-15R outlet for 100-120 V (or a NEMA 6-15R

outlet for 200-240 V)

• Is AC power available at the wall outlet?

• Are all integrated components from the tested components lists?

Check the tested memory, and chassis lists, as well as the supported

BS811.f/cppl!!Qbhf!94!!Uvftebz-!Opwfncfs!37-!3113!!21;19!BN

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 134 135

Keine Kommentare

Acer Altos R700 Series Bedienungsanleitung Seite 93