Acer P5290 Series Betriebsanweisung PDF herunterladen (Seite 55)

English

Replacing the Lamp

Use a screwdriver to remove the screw(s) from the cover, and then pull out the

lamp.

The projector will detect the lamp life. You will be shown a warning message

"Lamp is approaching the end of its useful life in full power operation.

Replacement Suggested!" When you see this message, change the lamp as soon

as possible. Make sure the projector has been cooling down for at least 30

minutes before changing the lamp.

Warning: The lamp compartment is hot! Allow it to cool down

before changing the lamp.

To Change the Lamp

1 Turn off the projector by pressing the power button.

2 Allow the projector at least 30 mins to cool down.

3 Disconnect the power cord.

4 Find the "OPEN" buttons on both sides of the projector and push it at the

same time. (Illustration #1)

5 Open the top cover. (Illustration #2)

6 Remove the two screws that secure the lamp module

X and pull up the

lamp bar

Y.(Illustration #3)

7 Pull out the lamp module by force. (Illustration #4)

To replace the lamp module, reverse the previous step.

Warning: To reduce the risk of personal injury, do not drop the

lamp module or touch the lamp bulb. The bulb may shatter and

cause injury if it is dropped.

Lens Shift Control

LENS SHIFT PROJECTOR

OPEN

Lens Shift Control

OPEN

LENS SHIFT PROJECTOR

Lens Shift Control

LENS SHIFT PROJECTOR

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 69 70

Keine Kommentare

Acer P5290 Series Betriebsanweisung Seite 55