Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung PDF herunterladen (Seite 20)

Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller

2-6 PCI Disk Array Controller Drivers Manual

Installing the Mylex Disk Array Controller as the

Primary NetWare 5.0 Controller

If the Mylex Disk Array Controller will be the primary (bootable) controller,

you must install the controller driver at the time of NetWare 5.0 installation.

If you choose to use the NetWare 5.0 bootable CD-ROM, please read the

instructions in the section “NetWare 5.0 Bootable CD-ROM” on page 2-7,

before continuing.

Installing NetWare 5.0 Drivers

NetWare version 5.0 is available on CD-ROM. Drivers provided in the \DOS

subdirectory of the NT4/NW Drivers Software Kit diskette (packaged with

the Mylex Disk Array Controller) are required to install NetWare 5.0 from a

CD-ROM drive connected to a Mylex Disk Array Controller.

The procedure below assumes that the CD-ROM drivers are available.

1. Boot the system from a newly created DOS boot drive, and then create

(or edit) the CONFIG.SYS and AUTOEXEC.BAT files to include the

drivers required for accessing the CD-ROM as a logical drive under

DOS. The following example assigns the CD-ROM as drive D: under

MS-DOS 6.00 or above. CONFIG.SYS contains the statements:

device = [pathname]\aspidac.sys

device = [pathname]\btcdrom.sys /D:[devicename]

AUTOEXEC.BAT contains the statement:

[pathname]\mscdex /v /m:10 /D:[devicename]

The device name is that of the specific CD-ROM drive

(e.g., MSCD001).

2. Boot the system with the new CONFIG.SYS and AUTOEXEC.BAT,

and make sure the NetWare CD-ROM files are accessible under DOS.

3. Create a directory C:\NWUPDATE

• Copy MDAC.HAM and MDAC.DDI from the \NETWARE path.

Copy A:\Netware\MDAC.* C:\NWUPDATE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Keine Kommentare

Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung Seite 20