Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung PDF herunterladen (Seite 63)

SCO OpenServer

Manual No. 775079 5-3

Installing the Mylex Disk Array Controller as the

Primary Controller

This section provides guidelines for the system administrator to follow

during the installation of SCO UNIX to prepare it for using the Mylex Disk

Array Controller (DAC) as the primary controller. The following guidelines

will focus mainly on the important steps for installing the SCO UNIX

drivers. For detailed information about the operating system installation,

consult the SCO UNIX documentation.

If a tape drive connected to the controller is being used for installation, make

sure that the tape drive is set to SCSI ID 2, that the configuration utility has

been run with the tape drive installed, and that the configuration has been

saved. The same is also true when using a CD-ROM, except the CD-ROM

needs to be set to SCSI ID 5.

Prepare the system to receive the SCO OpenServer 5.0.x driver by

performing the following procedure:

1. Insert the OpenServer Boot Disk into the primary floppy and boot the

system. The following prompt will be displayed:

Boot

2. Type ahslink at the colon(:) and press <Enter>.

: ahslink ↵

When running SCO 5.0.x on a system with an additional SCSI

controller, to install the controller at the boot prompt, enter:

Boot: defbootstr ahslink=mdac Sdsk=mdac(0,0,0,1)

If installing onto a system that is SISL capable and using a SISL

capable DAC, it is recommended to disable the SCSI chip driver on the

system by entering the following at the boot prompt:

Boot: defbootstr ahslink=mdac Sdsk=mdac(0,0,0,1)

disable=[scsi chip driver name]

3. The system will display the following message

What packages do you need linked in the system,

or q to quit?:

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

Keine Kommentare

Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung Seite 63