Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung PDF herunterladen (Seite 75)

UnixWare

Manual No. 775079 6-3

Creating a Driver Diskette for UnixWare

Before installing the Mylex Disk Array Controller Drivers for UnixWare,

a UnixWare driver diskette must be created according to the instructions in

Appendix A, “Creating PCI Driver Installation Diskettes.”

This diskette will be used in both the primary and secondary installation

processes and when updating a previously installed driver wherever

instructed to insert the “Software Kit UnixWare (dak) driver diskette.”

Installing the Mylex Disk Array Controller as the

Primary UnixWare Controller with UnixWare 7.x/

2.1.3

If the Mylex Disk Array Controller will be the primary (bootable) controller,

follow the instructions below.

☛ Note

If you are installing UnixWare 2.1.2 as a primary

controller, please refer to “Installing the Mylex Disk

Array Controller as the Primary UnixWare Controller

with UnixWare 2.1.2” on page 6-6.

1. Follow the instructions in the appropriate Mylex Disk Array Controller

manuals to set up the hardware, install the controller, connect the disk,

tape, and/or CD-ROM drives, and run the Mylex Disk Array Controller

Configuration Utility to create Drive Groups and System Drives.

☛ Note

CD-ROM or tape drives may be connected to any

channel on the first controller. Do not set the SCSI ID

of either CD-ROM drives or tape drives to ID 0.

2. Initialize all the System drives using the RAID EzAssist Configuration

Utility. Make sure the first System drive is less than 2GB.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 99 100

Keine Kommentare

Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung Seite 75