Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung PDF herunterladen (Seite 77)

UnixWare

Manual No. 775079 6-5

Installing the Mylex Disk Array Controller as the

Secondary UnixWare Controller with UnixWare

7.x/2.1.3

If UnixWare is installed on a Mylex controller, the Mylex Disk Array

Controller driver for UnixWare is already installed in the system. Simply

install the new Mylex Disk Array Controller hardware.

☛ Note

If you are installing UnixWare 2.1.2 as a secondary

controller, please refer to “Installing the Mylex Disk

Array Controller as the Secondary UnixWare

Controller with UnixWare 2.1.2” on page 6-8.

If UnixWare is installed on a non-Mylex controller, install the Mylex Disk

Array Controller driver for UnixWare as follows:

☛ Note

If installing onto a system that is SISL capable and

using a SISL capable DAC it is recommended to

disable the SCSI chip driver on the system by entering

the DCU at the appropriate screen then select

Software Device Drivers and disable the appropriate

driver.

1. Insert the Software Kit UnixWare (dak) driver diskette into the floppy

diskette drive, please refer to “Creating a Driver Diskette for

UnixWare” on page 6-3.

2. Type the following (match case exactly as shown):

pkgadd -d diskette1 dak ↵

The new controller driver is installed.

3. Rebuild the Kernel:

/etc/conf/bin/idbuild -B ↵

4. Reboot the system:

shutdown -i0 -g0 -y ↵

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 99 100

Keine Kommentare

Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung Seite 77