Acer PCI Disk Array Controller Drivers 08P4100 Bedienungsanleitung Seite 80

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 100
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 79
Installing the Mylex Disk Array Controller as the Secondary UnixWare Controller with UnixWare 2.1.2
6-8 Manual No. 775079
6
U
N
I
X
W
A
R
E
Installing the Mylex Disk Array Controller as the
Secondary UnixWare Controller with UnixWare
2.1.2
Mylex multifunction controllers use firmware 4.x or above. A special patch
is required for operation of these controllers with UnixWare 2.1.2 (not
required for UnixWare 7.x on x86 or UnixWare 2.1.3). UnixWare must
already be installed on another controller before you may install this special
patch. Follow the steps below to download the patch file and create a
diskette:
Note
If you are installing UnixWare 7.x or UnixWare 2.1.3
as a secondary controller, please refer to Installing the
Mylex Disk Array Controller as the Secondary
UnixWare Controller with UnixWare 7.x/2.1.3 on
page 6-5.
1. Download the following file from the Technical Support area of the
Mylex web site:
pcipatch.exe
2. Insert a non-bootable DOS-formatted floppy diskette in the diskette
drive and run:
pcipatch.exe a:
Use the diskette youve just created when requested in the procedure below.
To install the UnixWare driver for the Mylex Disk Array Controller:
Note
If installing onto a system that is SISL capable and
using a SISL capable DAC it is recommended to
disable the SCSI chip driver on the system by entering
the DCU at the appropriate screen then select
Software Device Drivers and disable the appropriate
driver.
1. Insert the patch diskette in the file servers diskette drive.
2. Type the following (match case exactly as shown):
Seitenansicht 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare