Acer PCI to Ultra SCSI RAID Controllers DAC960PG Bedienungsanleitung PDF herunterladen (Seite 48)

Installation Abort

C-2 DAC960PG and DAC960PJ Installation

During the initialization, if the firmware fails to respond to the BIOS inquiry

within two minutes, the following message displays:

DAC960Pn not responding--no drives installed.

The BIOS then inquires the firmware for its version number and other

information, and prints out the following message:

DAC960Pn firmware version x.xx

One or more of the following messages will be displayed if the firmware

reports the following conditions:

Warning: X system drives are offline

Warning: X system drives are critical

Warning: The following SCSI devices are dead--chn

x, tgt y...

No system drives found: None installed

X system drives installed

The BIOS repeats the same process for additional RAID controllers present

in the system. Then it proceeds to boot, if possible, from the first system

drive on the first controller.

Installation Abort

With Firmware 4.x, the installation aborted message is displayed when the

BIOS finds that the configuration of the disk drives, as stored in the

NVRAM and configuration on disk, is different from what it senses at boot

time. When this happens (and a brand new installation is not being

attempted), the cause is often a faulty cable or drive, or a loose connection.

Check all of the connectors, cables, drives, and try to boot. If the error

persists, it most likely indicates a genuine failure and needs to be corrected.

To correct it, boot and run the on-board Mylex Disk Array Configuration

Utility (see Chapter 4). For more information, refer to the RAID EzAssist

Configuration Utility User Reference Guide, available on CD-ROM, or

RAID EzAssist Configuration Utility Quick Configuration Guide.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Keine Kommentare

Acer PCI to Ultra SCSI RAID Controllers DAC960PG Bedienungsanleitung Seite 48