Acer Note Nuovo Bedienungsanleitung PDF herunterladen (Seite 115)

6-8 User’s Manual

6.4.2 Diskette Drives

The default setting for Diskette Drive A is

[1.44 MB 3.5-inch]

and

refers to the floppy drive whether it is installed in the module bay or

connected externally via the parallel port. Diskette Drive B by default is set

[None]

, and is only enabled if two floppy drives are connected to the

notebook.

6.4.3 Hard Disks

The Hard Disk 0 parameter is reserved for the hard disk. With this

parameter set to

[Auto]

, the BIOS automatically detects the hard disk

parameters and displays the formatted capacity in the parentheses right after

the Hard Disk 0 parameter heading. It also displays the cylinder, head and

sector values of the hard disk. Advanced hard disk settings are auto-

configured by Setup for optimum drive performance.

You can also choose to key-in the drive parameters by setting Hard Disk 0 to

[User]

. To determine your drive parameters, check the data found on

your hard disk or supplied in the hard disk vendor documentation. We

suggest that you set this parameter to

[Auto]

to allow the BIOS to auto-

detect the drive parameters at each boot-up.

The Hard Disk 1 parameter is used when a CD-ROM drive module or future

IDE drive option is installed in the module bay. The default setting for both

parameters is

[Auto]

6.4.4 Num Lock After Boot

When enabled, Num Lock turns on after boot and the embedded keypad

acts as a numeric keypad. The default setting is

[Disabled]

6.4.5 LCD Expansion Mode

When enabled, the LCD screen shows in expanded mode. By default, this

parameter is set to

[Disabled]

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 156 157

Keine Kommentare

Acer Note Nuovo Bedienungsanleitung Seite 115