Acer AT2758ML Bedienungsanleitung PDF herunterladen (Seite 31)

Channel management

Open the Channel Management menu as

described on page 27. This menu provides

the following settings:

Auto scan

Auto scan allows you to scan for new or

deleted channels. If you completed the

setup wizard the first time you turned on

your TV, all available channels are listed.

To scan again, select the Auto Scan setting, and then your country from the

Country List. Use the directional keys to select Start tuning and press the OK

key.

Wait until the scan has finished; this will take several minutes.

Manual scan

Analog manual scan

You can manually add an analog channel by adjusting the settings here. Use

the up or down directional kays to select a setting to change, use the left or

right directional keys to change the setting. You may set: the analog channel

where the signal will be stored, the encoding system, which direction to search

through analog frequencies, fine tune to a specific frequency and if this

channel will be skipped in the channel list.

Use the left or right directional keys to change the channel being scanned.

Digital manual scan

You can manually add a digital channel by searching in specific UHF channels.

Use the left or right directional keys to change the channel being scanned.

Channel edit

You can edit the detected channels, to change how they are displayed in the

channel list. Use the up or down directional keys to select a channel, you can

perform different actions:

•Edit.

•Skip.

• Reorder.

• Decode (available for channels that require a decoder).

• Analog channel fine tune.

• Favourite list.

• Clean channel list (remove all detected channels).

Preferred audio language

If you are viewing an analog channel that supports multiple sound signals (e.g.

NICAM, Bilingual), you may set which signal is used.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Keine Kommentare

Acer AT2758ML Bedienungsanleitung Seite 31