Acer R-1200 Wartungshandbuch PDF herunterladen (Seite 28)

R-1200

R-1201

1. Disconnect the power supply cord.

2. Open the door and block it open.

3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Remove the one (1) screw holding the base cover to the

oven cavity back plate.

5. Remove the three (3) screws holding the base cover to

the oven cavity front face plate.

6. Open the base cover.

7. Release the two hood lamp sockets from the base cover.

8. Remove the base cover from the oven cavity by pulling

down and moving to the left slightly.

the terminal hole of the oven lamp socket with the small

flat type screw driver.

8. Now, the oven lamp socket is free.

TURNTABLE MOTOR AND FOOD LAMP SOCKETS REMOVAL

TURNTABLE MOTOR

9. Disconnect the wire leads from the turntable motor.

10.Remove one (1) screw holding turntable motor to the

oven cavity.

11.Now the turntable motor is free.

HOOD LAMP SOCKET

9. Screw the hood lamp off from the lamp socket.

10.Disconnect the wire leads from the lamp socket by

pushing the terminal hole of the lamp socket with the

small flat type screw driver.

11. Now, the lamp socket is free.

1. Disconnect the power supply cord and remove the oven

from wall and remove outer case. (Refer to procedure of

"Removal of Oven from Wall" and "Outer case Removal")

2. Open the door and block it open.

3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Turn the lamp socket and release it from the magnetron

duct.

5. Screw the oven lamp off from the lamp socket.

6. Now, the oven lamp is free.

7. Pull the wire leads from the oven lamp socket by pushing

OVEN LAMP AND LAMP SOCKET REMOVAL

POSITIVE LOCK

CONNECTOR (NO-CASE TYPE) REMOVAL

1. Disconnect the power supply cord and remove the oven

from wall and remove outer case. (Refer to procedure of

"Removal of Oven from Wall" and "Outer case Removal")

2. Open the door and block it open.

3. To discharge the high voltage capacitor, wait for 60

seconds.

4. Push the lever of positive lock

connector.

5. Pull down on the positive lock

connector.

CAUTION: WHEN CONNECTING THE POSITIVE LOCK

CONNECTORS TO THE TERMINALS, IN-

STALL THE POSITIVE LOCK

SO THAT THE

LEVER FACES YOU.

Positive lock

connector

Oven lamp

socket

Terminal

Wire lead

Terminal hole

Flat type small

screw driver

Terminal

Push

Pull down

Lever

Positive lock®

connector

6. Hold the fan duct to the magnetron with the one (1) screw.

7. Reconnect the wire leads to the fan motor, magnetron

and high voltage capacitor, referring to the pictorial

diagram.

Rear View

Side View

Gap

Rotor

Bracket

Stator

Groove joint pliers

Coil

Shaft

Axis

Stator

Rotor

These are the positions

that should be pinched

with pliers

Shaft

Table

Center of

bracket

8. Reinstall the wire leads to the hole of the fan duct.

9. Refer to procedure of "OUTER CASE REMOVAL". And

reverse their procedure. And reinstall the outer case.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Acer R-1200 Wartungshandbuch Seite 28

Kommentare zu diesen Handbüchern