Acer Veriton 3500 Bedienungsanleitung PDF herunterladen (Seite 93)

The following questions are possible situations that may arise during

the use of your computer and each is followed by easy answers and

solutions to the situation.

Q: I pressed the power switch but the system did not boot up.

A: Check the LED located beside the power switch.

If the LED is not lit, no power is being applied to the system. Do any of

the following:

• Check if the voltage selector switch located on the rear panel of

the computer is set to the correct voltage.

• Check if you plugged the power cable properly into an electrical

outlet.

• If you are using a power strip or AVR, make sure that it is plugged

in and turned on.

If the LED is lit, check the following:

• Is a nonbootable (nonsystem) diskette in the floppy drive? If yes,

remove or replace it with a system diskette and press Ctrl + Alt +

Del to restart your computer.

• The operating system files may be damaged or missing. Insert the

startup disk you created during Windows setup into the floppy

drive and press Ctrl + Alt + Del to restart your computer. This will

automatically diagnose your system and make necessary fixes.

However, if the diagnostic utility still reports a problem, then you

may have to perform the recovery process to restore your system

to its original default factory settings.

Note: For more information about recovering your system, refer

to page 80.

VT3500series_EN.book Page 83 Tuesday, April 16, 2002 11:24 AM

1 2 ... 88 89 90 91 92 93 94 95 96 97 98

Keine Kommentare

Acer Veriton 3500 Bedienungsanleitung Seite 93