Acer S10 Bedienungsanleitung PDF herunterladen (Seite 4)

ENEN

Using electrical power

• This product should be operated from the type of power indicated on the marking label. If you are not sure of the type

of power available, consult your dealer or local power company.

• Do not allow anything to rest on the power cord. Do not locate this product where people will walk on the cord.

• Do not overload a power outlet, strip or receptacle by plugging in too many devices. The overall system load must not

exceed 80% of the branch circuit rating. If power strips are used, the load should not exceed 80% of the power strip's

input rating.

Product servicing

Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points

or other risks. Refer all servicing to qualified service personnel.

Unplug this product from the wall outlet and refer servicing to qualified service personnel when:

• the plug is damaged, cut or frayed

• liquid was spilled into the product

• the product was exposed to rain or water

• the product has been dropped or the case has been damaged

• the product exhibits a distinct change in performance, indicating a need for service

• the product does not operate normally after following the operating instructions

Note: Adjust only those controls that are covered by the operating instructions, since improper adjustment of

other controls may result in damage and will often require extensive work by a qualified technician to restore

the product to normal condition.

Battery

This product uses a Lithium-Ion battery. Do not use it in a humid, wet and/or corrosive environment. Do not put, store or leave

your product in or near a heat source, in a high temperature location, in strong direct sunlight, in a microwave oven or in a

pressurized container, and do not expose it to temperatures over 60°C (140°F). Failure to follow these guidelines may cause

the Lithium-Ion battery to leak-acid, become hot, explode or ignite and cause injury and/or damage. Do not pierce, open or

disassemble the battery. If the battery leaks and you come into contact with the leaked fluids, rinse thoroughly with water

and seek medical attention immediately. For safety reasons, and to prolong the lifetime of the battery, charging will not occur

at low (below 0°C/32°F) or high (over 40°C/104°F) temperatures.

Replacing the battery pack

The PDA uses lithium batteries. Replace the battery with the same type as that which came bundled with your product. Use of

another battery may present a risk of fire or explosion.

Warning! Batteries may explode if not handled properly. Do not disassemble or dispose of them in fire.

Keep them away from children. Follow local regulations when disposing of used batteries.

Telephone line safety

• Disconnect all telephone lines from the equipment when not in use and/or before servicing.

• To avoid the remote risk of electric shock from lightning, do not connect the telephone line to this equipment during

lightning or thunderstorms.

Warning! For safety reasons, do not use non-compliant parts when adding or changing components.

Consult your reseller for purchase options.

1 2 3 4 5 6 7 8 9 ... 53 54

Keine Kommentare

Acer S10 Bedienungsanleitung Seite 4