Acer 101/201 Spezifikationen PDF herunterladen (Seite 37)

AcerRouter 101/201 and Modem

Modem can dial out, but won’ t

connect to the ISP

Check the initialization string set up. Be sure to

power off and power on the Modem after changing the string.

Basically default AT command is “ AT&F” and is available for most modems, but some

modems had its own initial AT command due to changeable serial port rate and you

can find this information on their user’ s manual. (For Example, US Robotics modem

initial string is “ AT&F1B1 )

For no dial tone telephone system, your initial AT command should add “ X1” as

“ AT&FX1”

Test the Modem in Diagnostics window of Telnet.

You can also use Ping command in MS-DOS mode to verify the network connection:

l Ping 127.0.0.1 to see if the TCP/IP stack is properly configured.

l Ping gateway IP (Default: 192.168.1.1) to check if the internal link of network

works.

l Ping DNS IP and observe whether the modem will dial or not, to check the

external link and modem connection.

l Ping a Internet domain name (Example: www.yahoo.com) to see if DNS

works.

When dialing into the AcerRouter

101/201, the Modem does not

seem to connect.

Make sure that you are on the AcerRouter 101/201 Dial-in User list.

Modem 2 cannot be enabled.

Check the rear panel of the device, the MODEM 2/CONFIG Switch must be set on the

MODEM 2.

If the Bandwidth-on-demand is set on the bandwidth allocation, lower down the

percentage of MODEM1 in the rule dialogue¡]the default setting is at 50%¡^.

Miscellaneous

I cannot get IP from AcerRouter

101/201. I have another DHCP

server on my LAN

If there are no Internet access for your network environment, we suggest that you

disable AcerRouter 101/201 DHCP server on the Intranet page. If your LAN can access

the Internet in default, we suggest that you disable your pre-existing DHCP server

services or separates them into two different segments.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Acer 101/201 Spezifikationen Seite 37