Acer AB460 F1 Bedienungsanleitung PDF herunterladen (Seite 113)

100

101

Removing a Blade Unit from the Enclosure

1. Power down the blade unit (see "Powering Down a Blade Unit"

above).

2. Squeeze both handles to depress the red sections then pull out

both handles completely and use them to pull the blade unit from

the enclosure.

Note: Blade Modules can be Hot-Plugged from the

enclosure.

Removing/Replacing the Blade Cover

The blade cover must be removed to access the mainboard when you

need to install or remove processors, memory units, the onboard

battery and so on.

Removing/Replacing the Blade Cover

1. Remove the blade unit from the enclosure (see "Removing a Blade

Unit from the Enclosure" above).

2. Depress the two buttons on the cover while pushing the cover

toward the rear of the blade unit. When it stops, lift the cover off

the blade unit.

3. To replace the cover, fit the six grooves in the cover into the studs

in the sides of the blade, then slide the cover toward the front of

the blade to lock it into place.

Installing a Blade Unit into the Enclosure

Make sure the cover of the blade unit has been replaced first before

installing a blade unit in the enclosure.

Installing a Blade Unit into the Enclosure

1. Slowly push the blade unit into its bay with the handles fully

pulled out (see Figure 3-55).

2. When the blade stops, push the handles back in to their locked

position, making sure the notches in both handles catch the lip of

the enclosure (see Figure 3-56).

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 617 618

Kommentare zu diesen Handbüchern

Keine Kommentare

Acer AB460 F1 Bedienungsanleitung Seite 113

Kommentare zu diesen Handbüchern