Acer AB460 F1 Bedienungsanleitung PDF herunterladen (Seite 289)

100

101

269

Note: If two GbE switches are installed in a AB7000 system, you will

have to change the IP address of one from the default so that

both switches have unique addresses.

Command Line

Configuring the 1/10G Ethernet switch can be done using a command

line via telnet or by using the serial console interface.

Accessing CLI through Telnet:

To access command line via telnet, follow the below steps.

1. Connect a PC to a network that is accessible to the switch.

For example, connect a PC to any of the front panel ports of the switch

and make sure the PC has an IP address on the same subnet as the

switch management IP.

2. In the PC, start a telnet client session with the switch management

IP (default IP is 192.168.100.102).

This brings up the switch’s command line interface for user login.

3. Enter username and password to login to the switch.

4. To view the switch configurations use show commands and to

configure the switch type config term to get access to the

configuration commands. For help type ? or help.

Accessing CLI through a Serial Console

To access command line via a serial console, follow the below steps.

1. Connect a PC serial port to the switch console port.

2. In the PC, open any seral port access applications, such as

Hyperterminal or Term Term.

Address Default Setting

Default IP Address 192.168.100.102

Default Acer Address 192.168.100.1

Default Subnet Mask 255.255.255.0

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 617 618

Kommentare zu diesen Handbüchern

Keine Kommentare

Acer AB460 F1 Bedienungsanleitung Seite 289

Kommentare zu diesen Handbüchern