Acer AB460 F1 Bedienungsanleitung PDF herunterladen (Seite 354)

100

101

4 Networking Switch Modules

334

Stack Configuration

Clicking the STACK SETTINGS tab brings up the STACK CONFIGURATION page,

which configures the stacking feature. The parameters for this page

are shown in the following table.

Figure 4-213. Stack Configuration

Parameter Description

Switch ID This parameter defines a switch identifier number for

this switch. This identifier should be unique in the

stack, since the number is used in referring all physical

interfaces available in this switch.

So for example, if this parameter is choosen as

, the

physical interfaces will be referred as

Gi2/1

and

so on.

For non-stacking, stand-alone cases this switch ID is

considered as

zero

Ports This parameter represents the number of stacking

ports. You can choose the number based upon your

preferred stacking configuration and available CX4

ports. It is recommended that you use two CX4 ports as

stacking ports to get redundancy.

Priority This parameter chooses the priority for this switch in

the Stacking Master selection. It could be configured as

Preferred Master

Backup Master

Preferred Slave

1 2 ... 349 350 351 352 353 354 355 356 357 358 359 ... 617 618

Kommentare zu diesen Handbüchern

Keine Kommentare

Acer AB460 F1 Bedienungsanleitung Seite 354

Kommentare zu diesen Handbüchern