Acer AB460 F1 Bedienungsanleitung PDF herunterladen (Seite 40)

100

101

2 Chassis Enclosure

To reset these values, press and hold the Reset button for five seconds.

USB Switch

Figure 2-10. USB Switch on Rear of CMM

The USB ports on the CMM can function in either 2.0 or 1.1 mode (the

default is 1.1). A switch located on the PCB at the back of the CMM

module is used to change the USB mode (see Figure 2-10).

To access the switch, you need to remove the CMM from the enclosure.

Pull the CMM out and locate the switch near the large gray connector.

The settings are silk screened on the PCB. After setting the switch,

insert the CMM module back into its bay.

Module Installation

Make sure the cover to the module has been installed before

proceeding.

Installing the Module:

1. Remove the dummy cover from the bay you want to place the

module in.

2. Place the module's release handle in the open position.

3. Slide the module into the module bay until it stops.

4. Push the release handle to the closed position.

5. After the module has been installed and the handle locked, it will

turn on and a POST test will run to verify it is working properly.

Subnet Mask Reset to 255.255.255.0

Software Setting Default

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 617 618

Kommentare zu diesen Handbüchern

Keine Kommentare

Acer AB460 F1 Bedienungsanleitung Seite 40

Kommentare zu diesen Handbüchern