Acer 528T Bedienungsanleitung PDF herunterladen (Seite 5)

refer to following figure for an illustration of such a connection.

4. Take caution that you need to attach a 50ohm terminator on both

ends of the BNC cable.

Note: If port1 (BNC PORT) does not connect to the coaxial cable

after power is applied to the hub, port1 (BNC PORT) Partition LED

will be blinking. The port1 Partition LED will be OFF after

connecting the coaxial cable to port1.

The following diagram illustrates 10BASE-T and 10BASE2 network

connections.

Cascading Hubs by using 10Base-T port

When your 10BASE-T network needs to grow to more than eight

connections, you should consider to purchase an additional hub and

cascading it to the original hub.

The AcerHub 528B features a cascade enabling switch to allow port No.

9 to cascade to next hub.

The following diagram illustrates 10BASE-T cascading. In IEEE 802.3

standard, It allows in maximum 4 hubs being cascaded by using

10Base-T port.

1 2 3 4 5 6 7 8

Keine Kommentare

Acer 528T Bedienungsanleitung Seite 5