Acer V.90 Wartungshandbuch PDF herunterladen (Seite 44)

Chapter 2 39

Set Supervisor/User Password

If password on boot is required, the password must be set otherwise it cannot be enabled.

The formats of the password are as follows:

Length No more than 8 characters

Characters 0-9,A-Z (not case sensitive)

While these fields are highlighted and press “Enter”, a window similar to the following is shown:

If there is an old password then setup will prompt with the following window instead and a current password

will be required to be entered at first:

Set HDD Password When shown as [Locked], the hard drive

password currently can not be changed

or disabled.

To change or disable it, turn off the

system and enter Setup immediately after

turning it back on.

Press [Enter] to input change, or disable

hard drive password.

Enter

Password on boot Defines whether a password is required

or not while the events defined in this

group happened. The following sub-

options are all requires the Supervisor

password for changes and should be

grayed out if the user password was used

to enter setup.

Allows the user to specify whether or not

a password is required to boot.

Disabled

Enabled

Parameter Description Option

Set SupervisorPassword

Enter New Password [ ]

Confirm New Password [ ]

Set Supervisor Password

Enter current password [ ]

Enter New Password [ ]

Confirm New Password [ ]

download service manual and resetter printer at http://printer1.blogspot.com

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 102 103

Keine Kommentare

Acer V.90 Wartungshandbuch Seite 44