Acer FotoPrisa 300P Bedienungsanleitung PDF herunterladen (Seite 15)

FotoPrisa

1.4 Prepare to print

This section shows you how to prepare the printer for printing

images. Follow these steps when you use the FotoPrisa Printer

to print images.

Step 1- Turn on the printer power

Turn the power switch ON and wait until the printer completes

its self-test. The “READY” LED indicator will first blink for a few

seconds then remain on. If you find the “STATUS” LED indicator

blinking red intermittently after the self-test, go to Chapter 5 to

check if problem occurs within your printer.

Step 2- Replace ribbon cartridge (when necessary)

If the print ribbon cartridge is used up, you can replace the old

cartridge with a new one after the printer is powered on. Refer

to the following steps to change ribbon cartridge:

1. Open the ribbon cartridge cover. Lift the ribbon cartridge

hook to release the ribbon cartridge.

2. Gently pull the ribbon cartridge out by holding the handle on

the cartridge.

3. Before loading the new ribbon cartridge into the printer,

take up the slack by rotating the ribbon roller as shown in

the figure. When doing so, keep away from dust and do not

touch the ribbon.

Ribbon cartridge hook

“READY” LED

“STATUS” LED

Do not replace the ribbon cartridge while

the READY LED indicator blinks.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Keine Kommentare

Acer FotoPrisa 300P Bedienungsanleitung Seite 15