Acer Aspire M5802 Technical Information Seite 55
- Seite / 105
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 4 47
POST Error Messages List
If you cannot run the diagnostics program tests but did receive a POST error message, use "POST Error
Messages List" to diagnose system problems. If you did not receive any error message, look for a description
of your error symptoms in "Error Symptoms List"
NOTE: When you have deemed it necessary to replace an FRU, and have done so, you must run a total
system check to ensure that no other activity has been affected by the change. This system check can
be done through the diagnostics program.
NOTE: Check all power supply voltages, switch, and jumper settings before you replace the main board.
Also check the power supply voltages if you have a "system no-power" condition.
If you are unable to correct the problem by using the "BIOS Messages List" table and "Error Symptoms List"
table, go to "Undetermined Problems".
To diagnose a problem, first find the BIOS error messages in the left column. If directed to a check procedure,
replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU
listed in right column is the most likely cause.
Memory
Boot
Message
Displayed
Description
Gate20 Error The BIOS is unable to properly control the motherboard??s Gate A20 function, which
controls access of memory over 1 MB. This may indicate a problem with the motherboard.
Multi-Bit ECC
Error
This message will only occur on systems using ECC enabled memory modules. ECC
memory has the ability to correct single-bit errors that may occur from faulty memory
modules
A multiple bit corruption of memory has occurred, and the ECC memory algorithm cannot
correct it. This may indicate a defective memory module.
Parity Error Fatal Memory Parity Error. System halts after displaying this message.
RAM R/W test
failed
This message is displayed by the AMIBIOS8 when the RAM read/write test fails.
CMOS
Memory Size
Wrong
The base memory (memory below 1MB) size that is reported in the CMOS (offset 15h)
mismatches with the actual size detected. This condition may occur when the hole is set at
512K base memory or when CMOS is corrupted.
Message
Displayed
Description
Boot Failure ... This is a generic message indicating the BIOS could not boot from a particular device. This
message is usually followed by other information concerning the device.
Invalid Boot
Diskette
A diskette was found in the drive, but it is not configured as a bootable diskette.
Drive Not
Ready
The BIOS was unable to access the drive because it indicated it was not ready for data
transfer. This is often reported by drives when no media is present.
A: Drive Error The BIOS attempted to configure the A: drive during POST, but was unable to properly
configure the device. This may be due to a bad cable or faulty diskette drive.
- Aspire M5802(G) 1
- Service Guide 1
- Revision History 2
- Copyright 3
- Disclaimer 4
- Conventions 5
- Service Guide Coverage 6
- FRU Information 6
- Table of Contents 7
- System Tour 9
- Block Diagram 12
- System Components 13
- Rear Panel 14
- Main Board Major Chips 15
- Processor 15
- IOS Hotkey List 15
- Memory Combinations 16
- System Memory 16
- Audio Interface 16
- SATA Interface 17
- USB Port 17
- Environmental Requirements 17
- Power Management 17
- Device Standby Mode 18
- Global Standby Mode 18
- Suspend Mode 18
- System Utilities 19
- Entering CMOS setup 20
- Setup Utility Menus 21
- Product Information 22
- Standard CMOS Features 23
- Advanced BIOS Feature 24
- Advanced Chipset Features 25
- Integrated Peripherals 26
- Power Management Setup 27
- PC Health Status 28
- Frequency/Voltage Control 29
- BIOS Security Features 30
- Load Default Settings 31
- Save & Exit Setup 32
- Exit Without Saving 32
- System Disassembly 33
- Pre-disassembly Procedure 34
- Removing the Side Panel 35
- Removing the Processor 37
- Removing the VGA Card 38
- Removing the TV Card 39
- Removing the Mode Card 39
- Removing the Hard Disk Drive 40
- Chapter 3 33 41
- 3. Remove the HDD module 41
- Removing the Front Bezel 42
- Removing the Optical Drive 43
- Removing Cables 44
- Remove System FAN 45
- Removing the Power Supply 46
- Removing the Memory Modules 47
- Removing the Mainboard 48
- System Troubleshooting 49
- Power-On Self-Test (POST) 50
- DIM Code Checkpoints 54
- ACPI Runtime Checkpoints 54
- POST Error Messages List 55
- Storage Device 56
- Message 57
- Displayed 57
- Description 57
- Virus Related 58
- System Configuration 58
- Miscellaneous 60
- USB eModule Error Messages 61
- SMBIOS eModule Error Messages 61
- CPU eModule Error Messages 61
- Error Symptoms List 62
- Undetermined Problems 67
- Chapter 5 68
- Jumper Setting 70
- Setting Jumper 70
- Connector pin definition 73
- Chapter 6 78
- Aspire M5802 Exploded Diagram 79
- Chapter 6 72 80
- Aspire M5802 FRU List 81
- Chapter 6 74 82
- 75 Chapter 6 83
- Chapter 6 76 84
- 77 Chapter 6 85
- Chapter 6 78 86
- 79 Chapter 6 87
- Chapter 6 80 88
- 81 Chapter 6 89
- Intel RAID SOP 90
- 83 Chapter 7 91
- 87 Chapter 7 95
- Chapter 7 90 98
- HDD Drive ’ 99
- Existing HDD Drive ’ 100
- 93 Chapter 7 101
Verwandte Produkte und Handbücher für Server / Workstation-Motherboards Acer Aspire M5802
(161 Seiten)
(108 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.989 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern