Acer Aspire M5802 Technical Information Seite 56
- Seite / 105
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
48 Chapter 4
Storage Device
B: Drive Error The BIOS attempted to configure the B: drive during POST, but was unable to properly
configure the device. This may be due to a bad cable or faulty diskette drive.
Insert BOOT
diskette in A:
The BIOS attempted to boot from the A: drive, but could not find a proper boot diskette.
Reboot and
Select proper
Boot device or
Insert Boot
Media in
selected Boot
device
BIOS could not find a bootable device in the system and/or removable media drive does
not contain media.
NO ROM
BASIC
This message occurs on some systems when no bootable device can be detected.
Message
Displayed
Description
Primary
Master Hard
Disk Error
The IDE/ATAPI device configured as Primary Master could not be properly initialized by the
BIOS. This message is typically displayed when the BIOS is trying to detect and configure
IDE/ATAPI devices in POST.
Primary Slave
Hard Disk
Error
The IDE/ATAPI device configured as Primary Slave could not be properly initialized by the
BIOS. This message is typically displayed when the BIOS is trying to detect and configure
IDE/ATAPI devices in POST.
Secondary
Master Hard
Disk Error
The IDE/ATAPI device configured as Secondary Master could not be properly initialized by
the BIOS. This message is typically displayed when the BIOS is trying to detect and
configure IDE/ATAPI devices in POST.
Secondary
Slave Hard
Disk Error
The IDE/ATAPI device configured as Secondary Slave could not be properly initialized by
the BIOS. This message is typically displayed when the BIOS is trying to detect and
configure IDE/ATAPI devices in POST.
3rd Master
Hard Disk
Error
The IDE/ATAPI device configured as Master in the 3rd IDE controller could not be properly
initialized by the BIOS. This message is typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in POST.
3rd Slave Hard
Disk Error
The IDE/ATAPI device configured as Slave in the 3rd IDE controller could not be properly
initialized by the BIOS. This message is typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in POST.
4th Master
Hard Disk
Error
The IDE/ATAPI device configured as Master in the 4th IDE controller could not be properly
initialized by the BIOS. This message is typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in POST.
4th Slave Hard
Disk Error
The IDE/ATAPI device configured as Slave in the 4th IDE controller could not be properly
initialized by the BIOS. This message is typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in POST.
5th Master
Hard Disk
Error
The IDE/ATAPI device configured as Master in the 5th IDE controller could not be properly
initialized by the BIOS. This message is typically displayed when the BIOS is trying to
detect and configure IDE/ATAPI devices in POST.
Message
Displayed
Description
- Aspire M5802(G) 1
- Service Guide 1
- Revision History 2
- Copyright 3
- Disclaimer 4
- Conventions 5
- Service Guide Coverage 6
- FRU Information 6
- Table of Contents 7
- System Tour 9
- Block Diagram 12
- System Components 13
- Rear Panel 14
- Main Board Major Chips 15
- Processor 15
- IOS Hotkey List 15
- Memory Combinations 16
- System Memory 16
- Audio Interface 16
- SATA Interface 17
- USB Port 17
- Environmental Requirements 17
- Power Management 17
- Device Standby Mode 18
- Global Standby Mode 18
- Suspend Mode 18
- System Utilities 19
- Entering CMOS setup 20
- Setup Utility Menus 21
- Product Information 22
- Standard CMOS Features 23
- Advanced BIOS Feature 24
- Advanced Chipset Features 25
- Integrated Peripherals 26
- Power Management Setup 27
- PC Health Status 28
- Frequency/Voltage Control 29
- BIOS Security Features 30
- Load Default Settings 31
- Save & Exit Setup 32
- Exit Without Saving 32
- System Disassembly 33
- Pre-disassembly Procedure 34
- Removing the Side Panel 35
- Removing the Processor 37
- Removing the VGA Card 38
- Removing the TV Card 39
- Removing the Mode Card 39
- Removing the Hard Disk Drive 40
- Chapter 3 33 41
- 3. Remove the HDD module 41
- Removing the Front Bezel 42
- Removing the Optical Drive 43
- Removing Cables 44
- Remove System FAN 45
- Removing the Power Supply 46
- Removing the Memory Modules 47
- Removing the Mainboard 48
- System Troubleshooting 49
- Power-On Self-Test (POST) 50
- DIM Code Checkpoints 54
- ACPI Runtime Checkpoints 54
- POST Error Messages List 55
- Storage Device 56
- Message 57
- Displayed 57
- Description 57
- Virus Related 58
- System Configuration 58
- Miscellaneous 60
- USB eModule Error Messages 61
- SMBIOS eModule Error Messages 61
- CPU eModule Error Messages 61
- Error Symptoms List 62
- Undetermined Problems 67
- Chapter 5 68
- Jumper Setting 70
- Setting Jumper 70
- Connector pin definition 73
- Chapter 6 78
- Aspire M5802 Exploded Diagram 79
- Chapter 6 72 80
- Aspire M5802 FRU List 81
- Chapter 6 74 82
- 75 Chapter 6 83
- Chapter 6 76 84
- 77 Chapter 6 85
- Chapter 6 78 86
- 79 Chapter 6 87
- Chapter 6 80 88
- 81 Chapter 6 89
- Intel RAID SOP 90
- 83 Chapter 7 91
- 87 Chapter 7 95
- Chapter 7 90 98
- HDD Drive ’ 99
- Existing HDD Drive ’ 100
- 93 Chapter 7 101
Verwandte Produkte und Handbücher für Server / Workstation-Motherboards Acer Aspire M5802
(161 Seiten)
(108 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.914 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern