Acer SmartRAID V Bedienungsanleitung Seite 107

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 256
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 106
5-23
Software Installation
NetWare 5.0 – Secondary Controller
This section describes how to integrate a DPT SmartRAID VI controller
into a new or existing Novell NetWare 5.0 system as a secondary controller.
Ensure that your NetWare version is at the minimum patch level specified
by Novell.
NOTE NetWare 5 Support Pack 4 contains the latest Novell I
2
O
drivers. These drivers are newer than the ones from DPT but
have not been tested for compatiblity with DPT controllers.
To integrate a DPT controller into an existing Novell NetWare 5.0 system,
do the following:
1. Shutdown the server and switch off the power. Install the DPT
controller and any attached storage devices as a secondary disk
subsystem. Note the slot used by the controller, you will need this
information later in the install process.
2. Power on the server and use SMOR to configure the storage
subsystem. Press Ctrl+D during boot to start SMOR.
3. Start NetWare and insert the DPT NetWare diskette in the floppy
disk drive.
4. When the console prompt appears type, LOAD NWCONFIG and
press Enter.
5. Select DRIVER.
6. Select DISK DRIVER.
7. Install I2OPCI.NLM and BKSTROSM.HAM. You will need tospecify
A:\NW5 as the location for the files.
8. Ensure that I2OPCI.NLM is listed after BKSTROSM.HAM in your
STARTUP.NCF file.
Seitenansicht 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 255 256

Kommentare zu diesen Handbüchern

Keine Kommentare