Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 162)

6-50

Storage Manager

You must configure Remote Communication before it can be used. For

both workstations and servers, this is done by editing the DPT

configuration file (DPTMGR.INI). There may be additional server

configuration steps, depending on your operating system. You must have

physical connections between the servers and client workstations.

NOTE Under Windows 95/98, the server must be started manually by

selecting the DPT Communication Server icon. This version of

the communication server runs in a DOS window.

Editing the Configuration File

Both the workstation and server communication engines use the DPT

configuration file DPTMGR.INI. This file is contained in the directory in

which you installed Storage Manager.

The [OPTIONS] section of the file controls the behavior of the

communication server. To control the display of messages from the server,

change the Verbose parameter:

[OPTIONS]

Verbose=x

where x is:

0 No messages

1 Basic messages (such as errors, connects and disconnects)

2 More messages (option 1 messages + socket numbers and TCP/IP

addresses)

3 All messages (option 2 messages + message tracing)

The default is 1.

The [MODULES] section of the file tells the communication server the

protocol you want to use for communication.

[MODULES] (Specify as many as needed)

TCP (Comm server will use TCP protocol)

Each protocol can have its own section, in which you can set additional

parameters specific to the protocol. The following list shows all supported

options. The value listed is the default; optional values are in parentheses.

[TCP] (Available options for TCP protocol)

SOCKET=2091 (TCP socket on which to listen

Can be any valid socket number)

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 162