Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 51)

3-15

Adapter Configuration and Installation

Installing the Controller

1. Connect the computer’s disk activity LED cable to connector P6 on

the controller. See Appendix A, “Assembly Drawings” for the

location of this connector.

Pins 1 and 3 of P6 are connected to +5V and pins 2 and 4 are

connected to GND. Ensure that the positive lead of the LED cable

(usually a red wire or marked with a red stripe) is attached to pin 1

or 3 and the negative lead (usually a black wire) is attached to pin 2

or 4.

2. If you are using the internal SCSI cable, connect this cable to the

controller.

3. Install the controller in an available 32- or 64-bit PCI bus slot and

secure the controller bracket to the host system cabinet with the

screw provided.

In a system with multiple controllers, the controller that has the

lowest BIOS ROM address (typically, the lowest numbered PCI slot)

will become the booting controller. Refer to the “Determining the

Booting Controller” section for more information.

4. Connect any external cables to the controller.

NOTE If you have disk drives attached to a SCSI controller with a

Symbios chipset, use SMOR to set the Bootable Devices option

to Disable.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 51