Acer SmartRAID V Bedienungsanleitung Seite 70

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 256
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 69
4-14
SMOR
SCSI ID
SmartRAID V controllers are configured by default at SCSI ID 7. This
value should not be changed unless required for special configurations.
NOTE Fibre Channel IDs can be 0 126. However, these IDs are
configured dynamically and cannot be changed using SMOR
or Storage Manager.
TERMPWR
By default SmartRAID V controllers supply termination power for other
SCSI devices through the TERMPWR line on the SCSI cable. If you want
to change this setting, refer to the TERMPWR section in Chapter 7,
Theory of Operation for more information.
Termination
This setting controls the SCSI termination for the controller and bus. The
default value (Auto) should not be changed, unless both internal and
external cables are attached to the controller or you are using an 8-bit
(Narrow) cable. Refer to the Configuring SCSI Termination section in
Chapter 3, Configuration and Installation for information on setting this
parameter.
NOTE Termination is not used for Fibre Channel controllers.
SCSI Xfer Rate
DPT controllers automatically negotiate with each SCSI device at power-
up or reset to set the maximum SCSI transfer rate. This parameter limits
the SCSI transfer rate to the value selected. This setting should not be
changed except when you are troubleshooting SCSI bus errors.
NOTE If setting this parameter to 5MHz eliminates SCSI bus data
errors, this is usually an indication that the SCSI bus is too
long or that the bus is not terminated correctly.
PCI Xfer Rate
Mem Address
IRQ
These are display only fields for information purposes. The values in the
Mem Address and IRQ fields may be needed when you configure your
operating system.
Cluster Server Enable
This option enables or disables support for Microsoft Cluster Server
configurations using the selected controller. Do not enable this option
unless you are creating a cluster server configuration.
Seitenansicht 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 255 256

Kommentare zu diesen Handbüchern

Keine Kommentare