Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 74)

4-18

SMOR

Identification

The identification section displays a general description of the highlighted

array:

Description

The RAID level used for the array.

Revision

The firmware revision of the controller to which the

array is attached.

Address

The address of the array, in the form HBA n, Channel

n, ID n, LUN n. Arrays are always assigned the

lowest logical address of any device in the array. This

field displays as much information as is necessary to

unambiguously define the address of the array.

Capacity

The usable capacity of the array in megabytes. The

available capacity of an array depends on the RAID

level of that array.

Removable

As reported by the devices in the array.

Block Size

Displays the sector (block) size for the selected device

in bytes. For disk drives, this value should be 512. If

the value is not 512, use SMOR to perform a low-level

format and create 512 byte sectors.

Stripe Size

Displays the stripe size used to create the array.

SCSI Capabilities

This section displays the SCSI capabilities of the array, as reported to the

operating system. The capabilities reported depend on the devices that

were used to create the array.

Status

This field displays the current status of the array. A progress indicator (a

numeric percentage of completion) can also appear if the array is Building

or Rebuilding. See the following table for array status definitions.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 74