Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 78)

4-22

SMOR

Creating a Parity Group

Creating a parity group (RAID 0+1 or 0+5) is similar to creating a normal

RAID 1 or RAID 5 array group. Do the following to create a RAID 0+1 or

RAID 0+5 parity group:

1. Create and build your array groups as described in the preceding

section (Creating an Array).

Do not initiate the build process on any arrays that you intend to

use in a parity group.

2. After your initial array groups are created, select RAID–Create

again.

3. Select RAID 0 for the RAID type and click on OK.

4. Select two or more arrays of the same type from the Eligible Devices

list and click on Done.

NOTE You cannot combine arrays that use different RAID levels.

5. Select File–Set System Config to begin the build process for the

parity group.

The Tree View will display the parity group LSU as:

(x,x,x,x) FW RAID-0

with the array groups that were striped together listed where disk drives

would normally be listed. Selecting an array group component will branch

to the disk drives for that array group. The LSU address will be the lowest

address of the array logical addresses that make up the parity group.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 78