Acer SmartRAID V Bedienungsanleitung Seite 80

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 256
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 79
4-24
SMOR
Rebuilding a Failed Array
If a drive in a RAID 1 or RAID 5 array fails and the drive is not protected
by a Hot Spare, use the following procedure to replace the failed drive.
1. Remove and replace the failed drive according the procedures in
your hardware documentation.
2. When the failed drive has been replaced, choose RAID–Rebuild
Array to start the rebuild process.
The status of the array will change to Rebuilding (view the Information
window for that array). When the rebuild is complete, the array status will
change to Optimal.
NOTE A DPT RAIDstation enclosure will automatically detect the
replacement of a failed drive and initiate a rebuild operation
as soon as the new drive is online.
Formatting a Drive
Formatting SCSI hard drives is not normally required. However, if you
have a drive that was previously formatted with a sector size other than
512 bytes you must change the format to 512-byte sectors before you can
use the drive with a SmartRAID V controller. You can use SMOR to start a
low-level format operation and create a 512 byte/sector format.
IMPORTANT
Do not remove power from the drive until the format operation is completed.
Doing so can cause some drives to be left in an indeterminate state that will
require return to the manufacturer for repair or replacement.
Low-level formatting large capacity drives can take considerable time. Do
the following to start a low-level format for a disk drive:
1. Highlight the drive to be formatted.
2. Select Action–Format Drive.
3. Select OK and confirm.
To determine if the format has completed, view the Information
window for that drive.
Seitenansicht 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 255 256

Kommentare zu diesen Handbüchern

Keine Kommentare