Acer SmartRAID V Bedienungsanleitung Seite 87

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 256
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 86
5-3
Software Installation
There are three driver installation scenarios for Windows NT 4.0:
Installing the SmartRAID V controller into a new system, then
installing Windows NT 4.0
Upgrading an existing Windows NT 4.0 system
Adding a SmartRAID V controller into an existing Windows NT 4.0
system, to be used in addition to a currently installed SmartRAID IV
or SmartCache IV controller
Each of these cases requires a slightly different procedure. Be sure you
select the correct procedure and follow the procedure carefully. If you
need additional assistance, contact DPT Technical Support.
Installing a New System
This procedure describes how to install a SmartRAID V controller and
Windows NT 4.0 on a new system. If Windows NT is to coexist with another
operating system, that operating system must be installed before you
install Windows NT. During the Windows NT installation, you will need one
blank high-density diskette to create an Emergency Repair Diskette.
To install a SmartRAID V controller and Windows NT 4.0 into a new
computer system, follow the steps below:
1. Install the SmartRAID V controllers and storage devices according
to the instructions in Chapter 3, Configuration and Installation.
2. Boot your system and run SMOR to verify your configuration.
Create your disk arrays now. Each array will appear to the
operating system as a single logical drive.
3. Ensure that the Windows NT CD-ROM is in the CD-ROM drive.
Boot the system from the Windows NT setup diskette 1.
4. Insert the additional setup diskettes when prompted.
5. Press S to skip Setups mass storage detection. Press S to Specify
Additional Devices. Select Other, then insert the DPT diskette for
Windows NT.
6. Select DPT I2O SCSI Adapter Driver for NT 4.0 and greater.
7. Press Enter and continue with the installation as described in the
Windows NT documentation.
Seitenansicht 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 255 256

Kommentare zu diesen Handbüchern

Keine Kommentare