Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 93)

5-9

Software Installation

Installing Windows 95

(OEM SR2 – Version 950b)

This section describes the steps to install Windows 95 (OEM SR2 Version)

on one disk drive or array group using a SmartRAID V controller. Ensure

that your disk drives, arrays, CD-ROM drive, and any other SCSI devices

attached to the controller are recognized by SMOR before proceeding.

Do the following to install Windows 95 (OEM SR2 Version) with a

SmartRAID V controller:

1. Boot DOS from a bootable DOS diskette.

2. Run FDISK and create a Primary DOS Partition of an appropriate

size.

3. Mark the Primary DOS Partition Active.

4. Reboot the system from the DOS diskette.

5. Perform a system format (FORMAT C: /S).

6. Run the SETUPCD.EXE program on the DPT diskette. This

program will create an AUTOEXEC.BAT and CONFIG.SYS to

support your CD-ROM drive.

7. Ensure that the MSCDEX.EXE program is in your boot path or the

root directory of the C: drive.

8. Reboot the system from the C: drive.

9. Insert the Windows 95 OEM SR2 CD in the CD-ROM drive.

10. Enter the drive letter assigned to the CD-ROM and run SETUP (for

example, D:\SETUP).

11. Follow the Windows 95 installation prompts.

12. When Windows 95 is fully installed, start Device Manager (in

Control Panel – System) and look for a PCI Card entry under the

Other Devices category. There may be multiple entries if you have

multiple SmartRAID V host controllers installed. There may also be

an entry for PCI Memory Controller.

13. Select PCI Card and choose Update Driver from the Driver tab.

NOTE If you are not prompted for a PCI Card or Memory Controller

Driver or if the Device Manager shows PCI Card with a yellow

exclamation mark in the Other Devices list, you might need a

patch for your motherboard chipset to recognize multifunction

bridge controllers.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 93