Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 98)

5-14

Software Installation

SCO UNIX

A diskette for SCO UNIX 3.2V4.2 and SCO UNIX OpenServer 5 (3.2V5.x) is

included with your SmartRAID V controller. The DPT diskette for SCO

contains the drivers for both versions of SCO. A second diskette contains a

Motif version of DPT Storage Manager for each version of SCO UNIX.

NOTE When assigning numbers to controllers, SCO starts with zero.

Storage Manager numbers controllers starting with one.

Installing SCO UNIX 3.2V4.2 or OpenServer 5

This section describes the steps to install SCO UNIX 3.2V4.2 and up

(including ODT 3.x) and SCO UNIX 3.2V5.0.x (OpenServer 5) on a single

drive or array group. These SCO operating systems are configured to

support one SCSI hard drive or array group at ID 0, one tape drive at ID 2,

and one CD-ROM at ID 5. If these devices are to be installed at this time,

make sure that their IDs have been set accordingly.

To install SCO, follow the steps below:

1. If installing SCO UNIX 3.2V4.2 or ODT 3.0, boot the system with the

N1 diskette. Enter the following string at the boot prompt :

defbootstr link=dpti4

If installing SCO UNIX 3.2V5.0.x, boot the system with the Boot

Disk. Enter the following string at the boot prompt:

defbootstr ahslink=dpti5

For SCO UNIX 3.2V5.04 or later the command is:

defbootstr link=dpti5

2. When prompted for the SCO BTLD diskette (DPT volume), insert

the DPT BTLD diskette into the floppy drive.

3. Insert the N1 or Boot disk again when prompted.

4. If installing SCO 3.2V4.2 or ODT3.0, insert the N2 diskette when

prompted. During the Hardware Roster, the following line should

appear:

% adapter type=dpti ha=0 id=7 channel=0, PCI

If you are installing SCO UNIX 3.2V5.0.x., during the Hardware

Roster, the following line should appear:

% adapter type=dpti ha=0 id=7, PCI

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 98