Acer SmartRAID V Bedienungsanleitung PDF herunterladen (Seite 99)

5-15

Software Installation

5. Continue the installation according to the SCO documentation.

NOTE If you are installing from tape or CD-ROM, SCO UNIX 3.2V4.2

expects to find the tape at Controller 0, SCSI ID 2, LUN 0 and

the CD-ROM at Controller 0, SCSI ID 5, LUN 0.

SCO OpenServer 5 will locate the tape or CD-ROM at any

valid SCSI address.

Adding to an Existing SCO UNIX 3.2V4.2 or

OpenServer 5 System

When adding a DPT controller to an existing SCO UNIX configuration,

perform the following steps.

1. Install the DPT controller.

2. Boot SCO UNIX.

3. After SCO UNIX has booted, place the DPT SCO driver diskette in

the floppy drive.

4. Run the installpkg utility.

SCO UNIX will read the diskette and prompt you to enter the

package name to be installed. Enter dpti4 for SCO UNIX 3.2V4.2 or

ODT 3.0, and dpti5 for SCO OpenServer 5.

5. Rebuild the kernel after the package is installed. Shutdown and

reboot the system to install the new kernel and add devices on the

controller.

SCO UnixWare 7

1. Install the SmartRAID V controller as in Chapter 3, “Controller

Configuration and Installation”.

2. Obtain the latest I

O supplement for UnixWare 7 from SCO (it

should be PTF7067E or higher).

3. Copy or download the ptf file to the /tmp directory. Use the pkgadd

utility to install the I

O supplement by entering the command:

pkgadd –d /tmp/ptf7067e.s

4. Follow the on-screen prompts to install the SCO UnixWare I

supplement.

5. Shutdown and reboot the system.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 255 256

Keine Kommentare

Acer SmartRAID V Bedienungsanleitung Seite 99