Acer Altos R510 Bedienungsanleitung PDF herunterladen (Seite 73)

Installing a Floppy Drive into the Converted Hard

Drive Bay (Backplane Installed)

The slimline floppy drive conversion kit can only be installed into a

system that is using either the SATA or the SCSI backplane. You will

know if you have one of these backplanes installed if you can install

either hot-swap SATA or hot-swap SCSI drives. The conversion kit must

be installed in the left hard drive bay.

1 Observe the safety and ESD precautions at the beginning of this

book. See “Safety Information.”

2 Power down the server and unplug all peripheral devices and the

AC power cable.

3 Remove the chassis cover. For instructions, see “Removing the

Chassis Cover.”

4 Remove the front bezel if it is installed. For instructions, see

“Removing and Installing the Front Bezel.”

5 Remove the left hot-swap hard drive carrier from the chassis.

6 Remove the screws that attach the slide rails to the floppy drive

conversion kit carrier.

7 Slide the floppy drive into the drive carrier, rear of the drive first,

with the underside of the drive facing down.

8 Line up the holes in the side of the drive with the holes in the

carrier. See letter “A” in the figure below.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 197 198

Keine Kommentare

Acer Altos R510 Bedienungsanleitung Seite 73