25
Installing the hard drive
The AT110 accommodates up to four 3.5" SATA or SAS hard disk drives.
Note: Max HDD support is SKU dependent.
Installing a 3.5" HDD
1 Perform the pre-installation instructions described on page 22.
2 Remove the side panel described on page 24.
3 Remove an available HDD carrier fr
om the side of the chassis.
Press tabs together and pull the carrier out.
4 Slide the hard disk into the HDD carrier (1), making sure the tabs
are lined up (2).
5
Pull carrier over the HDD (3) and secure tabs into place (4).
Kommentare zu diesen Handbüchern