Acer DV653 Bedienungsanleitung PDF herunterladen (Seite 29)

Chapter 2

Preparation for use

Connecting LAN

Display connection using LAN

As shown in the illustration below, you can connect this display and a computer in network through a LAN hub.

Connect the display and the LAN hub using a straight type LAN cable (commercially available).

How to connect

• Turn off the main power switch of the computer and this display. If you make a connection while the power is on,

it the devices may fail.

• Connect the computer and the LAN hub using a straight type LAN cable (commercially available).

• Connect this display and the LAN hub using a straight type LAN cable (commercially available).

• When you connect two or more displays, you can connect the display and the LAN hub using a straight type LAN

cable (commercially available) as described above.

Connecting the power cord to the display

Connecting the power source

Before making connections

1 Check that the main power switch is off.

2 Insert the power plug into the power outlet socket.

• Fully insert the prongs into the power outlet socket. Loose connections may cause noise.

• Don’t plug and unplug the power cord repeatedly in a short period of time.

• When you use a cross type LAN cable (commercially available), you can connect the dis-

play and the computer one-to-one without using a LAN hub, however, the computer may

not be supported. It is recommended to check the operation in advance.

• If “LAN” control is selected, set “Standby Mode” to “Normal”; the power-on function with

LAN control will not work when Standby Mode is ECO.

Please refer to “Important Safety Instructions” and “Installation, Ergonomics, Care, and Ser-

vice” in this manual for proper selection of the AC power cord. Use the clamper to prevent

accidental disconnection of the power cord.

N O T E

UTC/cppl!!Qbhf!39!!Uvftebz-!Nbz!35-!3127!!6;66!QN

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 73 74

Keine Kommentare

Acer DV653 Bedienungsanleitung Seite 29