Acer Predator G Series Betriebsanweisung PDF herunterladen (Seite 38)

5 Upgrading your computer28

English

To install a memory module:

Note: DIMM slots on the mainboard must be installed only in certain

configurations. Numbers next to DIMM slots correspond to installation

sequence. DIMMs may be installed in pairs and in the correct order.

1 Perform steps 1 and 2 of the previous section.

2 Select an empty DIMM slot.

3 Open the holding clips on the DIMM slot.

If you are replacing an existing DIMM, install the new DIMM in the same slot

where you removed the DIMM.

If you are adding a new DIMM, note that the system supports dual channel

configuration. The total size of the DIMMs installed in the channel A slots must

match the total size of the DIMMs in channel B slots.

4 Remove the new DIMM from its protective packaging, handling it by the

edges.

5 Align the DIMM so that the notch on the slot fits the keyed edge of the module,

then press the module at both ends to seat it fully into the slot (1).

If you insert a DIMM but it does not fit easily into the slot, you have inserted it

incorrectly. Reverse the orientation of the module and insert it again.

6 Firmly press the holding clips inward to lock the DIMM in place (2).

If the holding clips do not close, the DIMM is not properly inserted.

7 Observe the post-installation instructions described on page 23.

The system automatically detects the amount of memory installed. Run the

BIOS setup to view the new value for total system memory and make a note of

it.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Keine Kommentare

Acer Predator G Series Betriebsanweisung Seite 38