Acer 2100 Bedienungsanleitung PDF herunterladen (Seite 37)

Chapter 1 - Getting Started 1-19

1.7.3 Correcting Error Conditions

As a general rule, the "Press F1 to continue" error message is caused by a configuration

problem which can be easily corrected. An equipment malfunction is more likely to cause

a fatal error, i.e., an error that causes complete system failure.

Here are some corrective measures for error conditions:

1. Run Setup. You must know the correct configuration values for your system before

you enter Setup, which is why you should write these values down when the system is

correctly configured. An incorrect Setup configuration is a major cause of power-on

error messages, especially for a new system.

2. Remove the system cover according to the directions in the system housing

installation guide. Check that the system board and any expansion boards are set

correctly.

3. Check that all connectors and boards are secure. Consult the system housing

installation guide for assistance.

If you have purchased a new hard disk drive

and cannot access it, it may be because your

disk is not physically formatted. Physically

format the disk using the FDISK and FORMAT

commands.

If you follow the corrective steps above and still receive an error message, the cause may

be an equipment malfunction.

If you are sure that your configuration values are correct and your battery is in good

condition, the problem may lie in a damaged or defective chip. Contact an authorized

service center for assistance.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 114 115

Keine Kommentare

Acer 2100 Bedienungsanleitung Seite 37