Acer T3103 Wartungshandbuch PDF herunterladen (Seite 12)

ASSEMBLY OF PRO-9 TENDERIZER, SCORING,

CUTLET AND STAR CRADLE ASSEMBLIES

NOTE: BIRO RECOMMENDS THE USE OF WIRE SAFETY CLEANING

GLOVES WHEN HANDLING CRADLE ASSEMBLIES.

STEP 1: Place the empty cradle on table top with plastic handle toward you, left hand cradle end away.

STEP 2:

Holding drive coupling end, insert back blade as-

sembly bearing #T3181-2, into large bearing hole on

right hand cradle end with bearing shoulder flat up.

Pivot shaft into the left hand cradle end slot.

STEP 4:

Holding the drive coupling end of the front blade

assembly in your left hand, grasp the drive coupling

end of the back blade assembly with your right hand

and pivot the rear tenderizer blades away from the

front knife blades.

STEP 5:

GENTLY pivot both blade assemblies together si-

multaneously. Make sure the front tenderizer blade

at the right hand cradle end is between the first two

rear tenderizer blades at the same end. Allow both

drive coupling ends to rest in the cradle supports.

NOTE:

STEP 3:

Holding drive coupling end, insert front blade as-

sembly #T3181-1, bearing slightly into small bearing

hole on right hand cradle end with bearing shoulder

flat up. CAUTION: DO NOT FORCE OR MAKE

CONTACT WITH REAR ASSEMBLY OR BOTTOM

OF CRADLE BAR OR BLADES WILL BE CHIPPED.

You must take extra care in this procedure

so as to match the back tenderizer blade as

sembly equally to the front cutting rollers in

the exact way it came from the factory. If as

sembled properly, no binding should occur

between the front and rear blade groups.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Keine Kommentare

Acer T3103 Wartungshandbuch Seite 12