Acer T3103 Wartungshandbuch PDF herunterladen (Seite 7)

II. OPERATION

SHARP ROTATING BLADES

TO AVOID SERIOUS PERSONAL INJURY

· ONLY Properly Trained Pesonnel Should Use This Equipment.

· ALWAYS Keep Hands Clear of Blades and Other Moving Parts.

· NEVER Operate With Safety Cover in Raised Position or Removed. Safety Cover MUST Be

Down During Operation.

· DO NOT Tamper With, Bypass, or Remove Safety Cover, Interlock Switch, or Toggle Switch.

· ALWAYS Turn Off and Unplug Machine from Power Source and Perform Lockout/Tagout

Procedures Before Cleaning, Servicing, or Attempting to Unjam or Unclog.

· NEVER Leave Unattended While Running.

· ALWAYS Turn Off Toggle Switch When Not in Use.

· ONLY Operate Machine By Using ON/OFF Toggle Switch.

· DO NOT Wear Gloves While Running.

· ALWAYS Wear Wire Mesh Safety Gloves When Touching or Handling Stew Cutter Attachments

for Removal and Cleaning Purposes Only.

A. TO PROCESS PRODUCT

1. Have product prepared prior to using this machine by slicing to appropriate size.

NOTE: The dimensions of the feed slot in the Safety Cover are the maximum size of product which can be

processed.

2. Make sure Safety Cover is in the down position.

3. Turn ON/OFF toggle switch to “ON” position.

4. Insert the product through the feed slot in Safety Cover. Observe the processing through the Safety Cover.

5. Product will exit at machine output under Blade Assemblies.

DO NOT WEAR GLOVES WHILE OPERATING.

NEVER REACH OR GRAB FOR PRODUCT AT MACHINE

OUTPUT – ALLOW PRODUCT TO DROP AND FULLY CLEAR

ROTATING BLADES BEFORE REMOVING PRODUCT.

1. Have product prepared prior to using this machine by slicing to appropriate size.

NOTE A. The dimensions of the feed slot in the Safety Cover are the maximum size of product

which can be processed.

TE B. Position Rear Comb T3117 into one of the rear slots which is your processing require-

ment - tenderizing or knitting. See illustration below.

2. Make sure Safety Cover is in the down position.

DO NOT WEAR GLOVES WHILE OPERATING.

COMB POSITIONS FOR

TENDERIZING & KNITTING

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Keine Kommentare

Acer T3103 Wartungshandbuch Seite 7