Acer AT350 F1 Bedienungsanleitung PDF herunterladen (Seite 62)

3 System upgrades

Removing and installing the processor

Processor configuration guidelines

This server has two LGA 1366 processor sockets for supporting Intel®

Xeon® 5500 / 5600 series series processors. The supplied processor may

be upgraded.

Observe the following guidelines when replacing or installing a

processor.

• The CPU socket must always be populated. If no processor is

installed in this socket, the system will fail to boot.

• Before removing the processor, make sure to back up all important

system files.

• Handle the processor and the heatsink fan assembly carefully.

Damage to either may prevent the system from functioning

properly.

Replacing the processor

Warning! The processor becomes very hot when the system is on.

Allow it to cool off first before handling.

1 Perform the pre-installation instructions described on page 26.

2 Remove the side panel described on page 28.

3 Lay the server on its side (components showing).

4 Remove the heatsink fan assembly (see "Removing and installing

the heatsink fan assembly" on page 45).

5 Remove the default processor.

(1) Press down on the load lever then release out of the retention

tab.

(2) Rotate the load lever to the fully open position until the

retention plate is completely lifted.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 183 184

Keine Kommentare

Acer AT350 F1 Bedienungsanleitung Seite 62